[Rhodes22-list] Saroj

[Saroj Gilbert]

that makes a lot of sense.. thanks a bunch...
Saroj
----- Original Message ----- 
From: <bestpestcontrol at earthlink.net>
To: "rhodes22-list" <rhodes22-list at rhodes22.org>
Sent: Friday, July 22, 2005 8:43 AM
Subject: [Rhodes22-list] Saroj


> Saroj, after removing the part or parts I took the nuts off the new bow 
> eye and ran the new bow
> eye in and out of the holes several times to clean the holes out . at this 
> time check to make sure it isnt moist in the holes--if it is moist dont 
> put the new eye in until the holes dry out--if  the
> holes are dry I used 3M 5200 both in the holes(generously) and on the 
> exterior mating surface
> I personally like to use too much sealant and wipe off the excess when 
> done.  once you apply
> sealer install the new eye right away--let it set overnight--then tighten 
> the nuts just a little more and that should do the job. 
> Barney
> __________________________________________________
> Use Rhodes22-list at rhodes22.org, Help? www.rhodes22.org/list