[Rhodes22-list] Stainless Steel Cutting Question

[Dave Bradley]

Brad, I've cut thicker steel with the grinder wheel attachment to my Dremel tool.  Though not that long a cut.   

Dave


-----Original Message-----
From: Brad Haslett <flybrad at gmail.com>
Sent: Saturday, August 16, 2008 2:30 PM
To: The Rhodes 22 Email List <rhodes22-list at rhodes22.org>
Subject: [Rhodes22-list] Stainless Steel Cutting Question

Dear Rhodies,

I need to cut an inspection panel about 1" x 4" in a stainless steel duct
that is located in tight confines.  My brother suggests a plasma torch but I
have some concerns about the current involved since some very expensive
electronics are located nearby.  Is there a Dremel cut-off wheel up to the
task or another tool/technique adequate for thin wall stainless? (guessing
1/16" thick).

Brad
__________________________________________________
To subscribe/unsubscribe or for help with using the mailing list go to http://www.rhodes22.org/list
__________________________________________________