[Rhodes22-list] Flooring and Shelving/also Rug replacement
elle
watermusic38 at yahoo.com
Mon Jan 28 21:05:59 EST 2008
Art,
No, I did not make a pattern, but it would not be a
big deal to take the carpeting out & make one. It'll
come right up once the table base is out.I'd be glad
to make a pattern if it will help others.
My carpeting was icky brown...& rough on tender
toes...
Would anyone like some pictures?? The weather is to be
nice tomorrow so I'll be down on the dock for a while.
elle
--- "Arthur H. Czerwonky" <czerwonky at earthlink.net>
wrote:
> Elle,
> Believe me, no thunder here. Did you make a pattern
> others might use? The one I got drops in or takes
> out. I'll not be able to post a picture until late
> next month when I'm in St Pete again. The only
> reason I brought this up is that others may come to
> conclusion, as I have, that their carpet is getting
> a bit grungy.
> Art
>
> -----Original Message-----
> >From: elle <watermusic38 at yahoo.com>
> >Sent: Jan 28, 2008 8:42 PM
> >To: The Rhodes 22 mail list
> <rhodes22-list at rhodes22.org>
> >Subject: Re: [Rhodes22-list] Flooring and
> Shelving/also Rug replacement
> >
> >Not to steal Art's thunder but I replaced the
> >carpeting in my boat with a nice piece of
> >rubber-backed carpeting from good ole Wally's. The
> >piece I used was large enough that it has no seams.
> >
> >I used the old carpeting as a pattern, cut the hole
> >for the table, marked the screw holes, etc. It goes
> >all the way back under the drawer under the step
> and
> >back to the bulkhead. Took about 20 min to cut and
> >place in the boat.
> >
> >It looks great, dries when it gets wet, matches the
> >curtains, and was inexpensive enuf to replace
> >whenever..
> >
> >I believe it cost under $20.
> >
> >
> >elle
> >
> >
> >--- Hank <hnw555 at gmail.com> wrote:
> >
> >> Art,
> >>
> >> I'll need some kind of rug to place over my
> floor,
> >> too. I'd certainly be
> >> interested in your solution.
> >>
> >> Hank
> >>
> >>
> >>
> >> On Jan 28, 2008 7:11 PM, Arthur H. Czerwonky
> >> <czerwonky at earthlink.net>
> >> wrote:
> >>
> >> > Bob,
> >> > This sounds like a neat installation. Some may
> >> want to replace/place a
> >> > new rug atop the cabin sole. I just had one
> made
> >> up, shaped to conform to
> >> > the floor, including a hole for the table
> mount.
> >> The edges are stitched and
> >> > the rug has a nice fresh look. If there is any
> >> interest I can follow-up.
> >> >
> >> > Art
> >> >
> >> > -----Original Message-----
> >> > >From: bobmellor <rhmello at aol.com>
> >> > >Sent: Jan 28, 2008 1:50 PM
> >> > >To: rhodes22-list at rhodes22.org
> >> > >Subject: Re: [Rhodes22-list] Flooring and
> >> Shelving
> >> > >
> >> > >
> >> > >Hank,
> >> > >
> >> > >I recently replaced the entire galley.... (as
> >> well as stringers and
> >> > cabin
> >> > >floor)
> >> > >
> >> > >galley..
> >> > >Used 3/4 marine ply for base and top... routed
> >> out thinner in spots to
> >> > keep
> >> > >weight down.
> >> > >Used some cheap vinyl flooring w/ small
> brown/tan
> >> pebble design on bottom
> >> > >shelf, white formica on counter top.
> >> > >Used thinner ply on upper shelf and upper
> shelf
> >> front face, with mahogany
> >> > >wood veneer stained to match rest of cabin.
> >> > >Still deciding best material/finish for
> sliding
> >> doors.
> >> > >
> >> > >stringers - used quartersawn douglas fir ..
> >> seemed to be what was there
> >> > >originally.
> >> > >
> >> > >Floor - Used 3/4 marine ply, coverd with loose
> >> piece of vinyl flooring
> >> > (same
> >> > >pebble design as galley bottom shelf.
> >> > >
> >> > >a good jig saw is all you really need to
> >> duplicate the shape, cutouts,
> >> > >bevels etc, but a router helps a lot. (and a
> >> good cordless drill/driver
> >> > is
> >> > >a must in my mind)
> >> > >
> >> > >Also.. regarding the floor...realize that the
> >> hull shape changes from
> >> > >trailer to water. I prepped everything on
> land,
> >> but put it all together
> >> > in
> >> > >the water. Result was I could not remove
> floor
> >> when on the trailer...
> >> > Thus
> >> > >be sure to leave enough space around edges so
> it
> >> can be removed in or out
> >> > of
> >> > >water.
> >> > >
> >> > >I also split the floor in two halves
> (lengthwise)
> >> so it can be taken out
> >> > if
> >> > >needed with much less disassembly of
> everything
> >> else... I reattach the
> >> > two
> >> > >halves with sturdy strips of 3/4 marine
> accross
> >> both ends.
> >> > >
> >> > >Thats about all i can think of at the moment..
> >> > >
> >> > >Bob M
> >> > >
> >> > >
> >> > >Hank-5 wrote:
> >> > >>
> >> > >> Hello fellow Rhodies,
> >> > >>
> >> > >> I need to replace the bottom shelf in our
> >> galley as the old one has
> >> > >> completely rotted out. I was thinking of
> using
> >> a Marine Grade plywood
> >> > for
> >> > >> this and then using the rest of the sheet to
> >> replace my cabin floor as
> >> > it
> >> > >> is
> >> > >> not in the greatest shape, either.
> >> > >>
> >> > >> Any recommendations on the best way to get
> this
> >> done? What is a good
> >> > >> supplier for the plywood? Any tricks or
> >> concerns I should be aware of
> >> > >> before I start?
> >> > >>
> >> > >> Thanks in advance,
> >> > >>
> >> > >> Hank
> >> > >>
> >>
> __________________________________________________
> >> > >> Use Rhodes22-list at rhodes22.org, Help?
> >> www.rhodes22.org/list
> >> > >>
> >> > >>
> >> > >
> >> > >--
> >> > >View this message in context:
> >> >
> >>
>
>http://www.nabble.com/Flooring-and-Shelving-tp15139097p15142484.html
> >> > >Sent from the Rhodes 22 mailing list archive
> at
> >> Nabble.com<http://nabble.com/>
> >> > .
> >> > >
> >> >
> >>
> >__________________________________________________
> >> > >Use Rhodes22-list at rhodes22.org, Help?
> >> www.rhodes22.org/list
> >> >
> >> >
> __________________________________________________
> >> > Use Rhodes22-list at rhodes22.org, Help?
> >> www.rhodes22.org/list
> >> >
> >>
> __________________________________________________
> >> Use Rhodes22-list at rhodes22.org, Help?
> >> www.rhodes22.org/list
> >>
> >
> >
> >We can't change the angle of the wind....but we can
> adjust our sails.
> >
> > 1992 Rhodes 22 Recyc '06 "WaterMusic" (Lady
> in Red)
> >
> >
> >
>
____________________________________________________________________________________
> >Be a better friend, newshound, and
> >know-it-all with Yahoo! Mobile. Try it now.
>
http://mobile.yahoo.com/;_ylt=Ahu06i62sR8HDtDypao8Wcj9tAcJ
>
> >
> >__________________________________________________
> >Use Rhodes22-list at rhodes22.org, Help?
> www.rhodes22.org/list
>
> __________________________________________________
> Use Rhodes22-list at rhodes22.org, Help?
> www.rhodes22.org/list
>
We can't change the angle of the wind....but we can adjust our sails.
1992 Rhodes 22 Recyc '06 "WaterMusic" (Lady in Red)
____________________________________________________________________________________
Never miss a thing. Make Yahoo your home page.
http://www.yahoo.com/r/hs
More information about the Rhodes22-list
mailing list