[Rhodes22-list] Steaming light plug

[Hank]

It should be the opposite.  Anchor lights are supposed to have 360 degree
visibility and steaming visibility from the front.

Hank

On Thu, Jun 4, 2009 at 9:45 AM, Lowe, Rob <rlowe at vt.edu> wrote:

> Well, looks like I misspoke earlier.  I do have two lights mounted on my
> mast, one at the very top and one where the spreaders are located.  Now
> if I could only read the notes on my diagram, I could tell which is
> which.  It looks like my anchor light switch goes to the mid mast light
> and my steaming light switch does to the light at the top of the mast.
> I did have to clean the connections to get a good contact.  I actually
> checked the lights with the mast down.  I used a 9V battery with a pair
> of small jumper wires and attached them to the prongs on the plug.  -
> rob
>
>
> -----Original Message-----
> From: rhodes22-list-bounces at rhodes22.org
> [mailto:rhodes22-list-bounces at rhodes22.org] On Behalf Of Joe Babb
> Sent: Tuesday, June 02, 2009 8:29 AM
> To: rhodes22-list at rhodes22.org
> Subject: [Rhodes22-list] Steaming light plug
>
> Looks like everybody's got something a little different.  I only have a
> "masthead light" switch on the control panel.
> I just redid the connections in the plug connected to the mast wiring.
> The big pin went to green and two smaller
> pins to either side of the big pin went to red and white wires.  As soon
>
> as I drop the mast I've got to check the lights.
> If there are two lights up there, the forward lamp is out or else there
> is a wiring problem.
> Joe
> __________________________________________________
> To subscribe/unsubscribe or for help with using the mailing list go to
> http://www.rhodes22.org/list
> __________________________________________________
>
> __________________________________________________
> To subscribe/unsubscribe or for help with using the mailing list go to
> http://www.rhodes22.org/list
> __________________________________________________
>