[Rhodes22-list] Thru hull fitting

[Chris Cowie]

Lee:

My sink was only two years old however the interior finish started to peel away from the fiberglass core.  It was primarily an aesthetic issue and Stan offered to send me a new sink.  The photo I sent in my previous message was the old sink.  The new one is the same size and I like the depth as well as room below for storage.  

Christopher P. Cowie    


Please consider the environment before printing this email.


-----Original Message-----
From: rhodes22-list-bounces at rhodes22.org [mailto:rhodes22-list-bounces at rhodes22.org] On Behalf Of KUHN, LELAND
Sent: Wednesday, March 23, 2011 11:16 AM
To: The Rhodes 22 Email List
Subject: Re: [Rhodes22-list] Thru hull fitting

Chris,

Did you replace your sink because you wanted a deeper one?

Lee
1986 Rhodes22  AT EASE
Kent Island, MD

-----Original Message-----
From: rhodes22-list-bounces at rhodes22.org
[mailto:rhodes22-list-bounces at rhodes22.org] On Behalf Of cowie
Sent: Wednesday, March 23, 2011 11:10 AM
To: rhodes22-list at rhodes22.org
Subject: Re: [Rhodes22-list] Thru hull fitting


Greg:

Thanks for the reply and link.  My thru hull for the sink drain is also
above the water line when the boat is level.  When replacing the sink I
found the drain line from the sink to the thru hull seemed loose and I
was
able to easily pull it off the thru hull.  Apparently the newer Rhodes
including mine has a metal thru hull that replaces the older plastic
thru
hulls GB used to use.  The newer metal thu hull has a male fitting that
is a
smaller diameter than the sink drain hose and It looks like a smaller
diameter pipe has been inserted into the larger sink hose to allow for
the
diameter transition.  I spread a generous amount of sealant around the
male
fitting and pushed the drain hose, with the smaller piece of hose
inside,
onto the fitting and tightened the hose clamp.  I will add a second hose
clamp per Frank's recommendation.  I didn't take any photos with the
hose
off the fitting but enclosed are a couple of general images.

http://old.nabble.com/file/p31220711/IMG_7065r.jpg 
http://old.nabble.com/file/p31220711/IMG_7067r.jpg 


Greg PA wrote:
> 
> Cowie
> Both my through hulls are above the waterline. Below is a link to a
great
> article about bedding hardware. I am not sure if you want to use Butyl
> Tape on through hull fittings, but I bought it to re-do my mast
bracket
> and to replace the nylon front cleat with a new SS one.
> 
> 
>  http://forums.sbo.sailboatowners.com/showthread.php?t=117172 Link 
> 
> 
> 

-- 
View this message in context:
http://old.nabble.com/Thru-hull-fitting-tp31197150p31220711.html
Sent from the Rhodes 22 mailing list archive at Nabble.com.

__________________________________________________
To subscribe/unsubscribe go to
http://www.rhodes22.org/mailman/listinfo/rhodes22-list

For the list Charter and help with using the mailing list and archives
go to http://www.rhodes22.org/list
__________________________________________________

__________________________________________________
To subscribe/unsubscribe go to http://www.rhodes22.org/mailman/listinfo/rhodes22-list

For the list Charter and help with using the mailing list and archives go to http://www.rhodes22.org/list
__________________________________________________