[Rhodes22-list] deck mounted chain plates

[The Rhodes 22 Email List]

Dennis:

That is very helpful. Thanks. I would have believed you if you said the
tension was thousands of pounds. Am I correct that the tension gauge would
give the tension when the rig is at rest and that it might increase
substantially in actual use - particularly when healing?

Graham Stewart


-----Original Message-----
From: rhodes22-list-bounces at rhodes22.org
[mailto:rhodes22-list-bounces at rhodes22.org] On Behalf Of The Rhodes 22 Email
List
Sent: January-10-15 8:42 PM
To: 'The Rhodes 22 Email List'
Subject: Re: [Rhodes22-list] deck mounted chain plates

I know the use of Loos gauge data is against Rummy's religion, but...

Take a look at http://loosnaples.com/how-to-use-pt-series-tension-gauges and
you'll see the suggested tension for a 1 x 19 stainless steel 1/8" in
diameter is 240 pounds. The Loos guide goes on to say "In some rigs it may
be advantageous to carry a bit more tension in the uppers than the lowers".
Sooo... figure 240 pounds in the lowers.

Given that Loos suggests that a 1/8" forestay should carry 320 pounds of
tension, and that my forestay is secured with a 3/16" pin, I'd guess is that
your bracket should work for the lowers. Give some consideration to the size
of the backing plate you'll use though.

Dennis
Magic Moments
The glaciers have advanced back down the Detroit River. Aarrrg!



-----Original Message-----
From: rhodes22-list-bounces at rhodes22.org
[mailto:rhodes22-list-bounces at rhodes22.org] On Behalf Of The Rhodes 22 Email
List
Sent: Saturday, January 10, 2015 7:04 PM
To: 'The Rhodes 22 Email List'
Subject: [Rhodes22-list] deck mounted chain plates

During the rebuild of Agile I removed the chainplates for the lower shrouds
with the intention of placing external chain plates on the cabin sides.
Subsequently I changed the design doe the windows such that I now need to
install deck mounted chainplates on the cabin top. Finding the right
hardware has turned out to be a challenge. I found something that looks
close to what I need but am unsure about its suitability - see attached.
Given that the old chainplates were fairly thin tangs that were bent around
the cabin deck core it would seem that this hardware is more than sufficient
for the purpose but thought I would check the list to see if anyone has an
opinion on these or  an alternative suggestion. Does anyone have a clue what
load the lower stays place on the boat?

Graham Stewart

__________________________________________________
To subscribe/unsubscribe go to
http://www.rhodes22.org/mailman/listinfo/rhodes22-list

For the list Charter and help with using the mailing list and archives go to
http://www.rhodes22.org/list
__________________________________________________