[Rhodes22-list] Cabin Liner

[Mark West]

I agree with Peter only difference the mast support bulkhead on my 1989 is hollow all wires are ran up bulkhead into the mast base concealed 


-----Original Message-----
From: Peter Nyberg <peter at sunnybeeches.com>
To: The Rhodes 22 Email List <rhodes22-list at rhodes22.org>
Sent: Wed, Dec 4, 2019 3:21 pm
Subject: Re: [Rhodes22-list] Cabin Liner

I agree with Graham that removing the liner isn’t a practical solution.

On my boat GB ran the wires for the mast from the electrical panel above the galley counter-top, down along the hull behind the icebox, under the cabinet base, then forward through a hole at the bottom of the bulkhead under the head floor, then up a chase along side the compression post.  From the top of the compression post, the wires are exposed for a few inches before running into a hole in the overhead just forward of the mast.  The boat has a semi-enclosed head layout.

Peter Nyberg
Coventry, CT
s/v Silverheels (1988/2016) 

> On Dec 4, 2019, at 11:40 AM, Lowe, Rob <rlowe at vt.edu> wrote:
> 
> Speaking of removing liners, has anyone attempted/figured out how to remove the liner in in the cabin?  I'm trying to run some wiring from my electrical panel to the mast area and would prefer not to cut into the liner.  Thanks - rob
>