[Rhodes22-list] Replacing diamondboard pendant

[Jesse Shumaker]

 Olivier, thanks for the photo.  Interestingly, the pendant for your
diamondboard attaches slightly differently than the one in John's photo.

On Mon, Jun 15, 2020 at 12:33 PM Olivier Hecht <oehecht at gmail.com> wrote:

> I just went through the process of pulling my diamondboard to repair it (on
> the trailer). Here is one picture where you can see the attachement point
> (right side of the board). There is a small metal “loop” connected to the
> board with a bolt and the pendant passes through that loop. Kind of a tight
> fit but it will pass through. Mine was connected with a bowline knot. The
> path the pendant travels below the visible hole on deck is through a short
> piece of garden hose that’s connected to the back of that hole and a
> fitting on the centerboard cap. The only place I think you might feel any
> resistance to passing the new line through is where the hose connects to
> the cap, but it should fit fine. Hope this helps.
>
> On Mon, Jun 15, 2020 at 11:49 AM stan <stan at generalboats.com> wrote:
>
> >
> > If the cb pendant is simply pulled straight up and then folded over into
> > the cleat, it takes a lot less energy and the line should last forever,
> >
> >
> -------------- next part --------------
> A non-text attachment was scrubbed...
> Name: IMG_3756.jpg
> Type: image/jpg
> Size: 3263503 bytes
> Desc: not available
> URL: <
> http://rhodes22.org/pipermail/rhodes22-list/attachments/20200615/2ab8b68d/attachment.jpg
> >
>