[Rhodes22-list] Pintle Screw size and availability

[Graham Stewart]

Mark:

If it would be helpful, I can take some photos of my rudder and the arrangement with the screws.

Graham Stewart
Agile, Rodes 22, 1976
Kingston Ontario







-----Original Message-----
From: Rhodes22-list [mailto:rhodes22-list-bounces at rhodes22.org] On Behalf Of Matt Wilson
Sent: Monday, June 14, 2021 9:10 PM
To: The Rhodes 22 Email List
Subject: Re: [Rhodes22-list] Pintle Screw size and availability

Thanks  everyone!!  I greatly appreciate it!

On Mon, Jun 14, 2021 at 8:02 PM Graham Stewart <gstewart8 at cogeco.ca> wrote:

> Those are just very short flathead machine screws. There should be one on
> each side. The head goes in from the inside and the locknut is what shows
> on
> the outside. Just get a stainless steel flat head machine screw that fits
> the hole diameter, insert it from the inside. Fasten the locknut and cut
> off
> the extra.
>
> Graham Stewart
> Agile, Rodes 22, 1976
> Kingston Ontario
>
>
>
>
>
> -----Original Message-----
> From: Rhodes22-list [mailto:rhodes22-list-bounces at rhodes22.org] On Behalf
> Of
> Hornblower
> Sent: Monday, June 14, 2021 12:02 PM
> To: rhodes22-list at rhodes22.org
> Subject: [Rhodes22-list] Pintle Screw size and availability
>
> Hi everyone,
>
> This is an amazingly helpful forum for a new Rhodes owner like me!  I am
> appreciating all the info and advice I read daily!
>
> My boat came to me missing the portside lower pintle screw seen in the
> picture.  Can anyone tell me exactly what size it is and where I can get
> another? Many thanks!
> Matt
>
> <http://rhodes-22.1065344.n5.nabble.com/file/t1016/IMG_3060.jpg>
>
>
>
> --
> Sent from: http://rhodes-22.1065344.n5.nabble.com/
>
>