[Rhodes22-list] In-hull transducer?

[Joe Dempsey]

Bob,
Mine is installed in the lazzarette on the centerline just behind the
cockpit drain pipe. I would not epoxy in case you have to remove/replace it.
I used clear silicone. Works fine.

Joe Dempsey
SV Respite
Deltaville, VA

-----Original Message-----
From: Rhodes22-list <rhodes22-list-bounces at rhodes22.org> On Behalf Of John
Keyser
Sent: Monday, July 25, 2022 4:08 PM
To: The Rhodes 22 Email List <rhodes22-list at rhodes22.org>
Subject: Re: [Rhodes22-list] In-hull transducer?

Hi Bob,
I put one in my boat at the same approximate place. No thru-hull
installation. Just epoxied it to the inside of the hull following the
manufacturers instructions. Works fine - no issues.
Good luck!
John Keyser
"Deci-Belle"
Philadelphia, Pa
________________________________
From: Rhodes22-list <rhodes22-list-bounces at rhodes22.org> on behalf of Bob
Garrant <bgarrant at gmail.com>
Sent: Monday, July 25, 2022 2:23 PM
To: The Rhodes 22 Email List <rhodes22-list at rhodes22.org>
Subject: [Rhodes22-list] In-hull transducer?

Hi folks,
I am installing an in-hull transducer.
I'm trying to figure out where to locate it. Thinking about placing it below
the cabin floor just offset from the centerboard sleeve.
Wondering if anyone in the group has installed an in-hill transducer and how
it was done.
Thanks very much
Bob Garrant
Sail la Vie
Kent Island, MD