[Rhodes22-list] In-hull transducer?

[Bob Garrant]

Thanks Lee

On Tue, Jul 26, 2022 at 1:34 AM Lee Kuhn <lvjkuhn at gmail.com> wrote:

> Same place Stan put mine on my '86.
>
> Lee
> 1999 Rhodes22. AT EASE
> Claytor Lake, VA
>
> On Mon, Jul 25, 2022, 10:54 PM <gstewart.gm at gmail.com> wrote:
>
> > I put mine in the lazarette between the bulkhead and the drain. I
> attached
> > a
> > short piece of pvc tube with 3M 4200 sealant and then installed the
> > transducer in the tube with DAB sealant so it can be removed easily. I
> > wanted to protect the transducer from shifting materials in the lazarette
> > and also have a system that could be relocated f necessary. This seems to
> > work well. If interested I can send a picture.
> >
> > -----Original Message-----
> > From: Rhodes22-list <rhodes22-list-bounces at rhodes22.org> On Behalf Of
> Joe
> > Dempsey
> > Sent: Monday, July 25, 2022 7:23 PM
> > To: 'The Rhodes 22 Email List' <rhodes22-list at rhodes22.org>
> > Subject: Re: [Rhodes22-list] In-hull transducer?
> >
> > Bob,
> > Mine is installed in the lazzarette on the centerline just behind the
> > cockpit drain pipe. I would not epoxy in case you have to remove/replace
> > it.
> > I used clear silicone. Works fine.
> >
> > Joe Dempsey
> > SV Respite
> > Deltaville, VA
> >
> > -----Original Message-----
> > From: Rhodes22-list <rhodes22-list-bounces at rhodes22.org> On Behalf Of
> John
> > Keyser
> > Sent: Monday, July 25, 2022 4:08 PM
> > To: The Rhodes 22 Email List <rhodes22-list at rhodes22.org>
> > Subject: Re: [Rhodes22-list] In-hull transducer?
> >
> > Hi Bob,
> > I put one in my boat at the same approximate place. No thru-hull
> > installation. Just epoxied it to the inside of the hull following the
> > manufacturers instructions. Works fine - no issues.
> > Good luck!
> > John Keyser
> > "Deci-Belle"
> > Philadelphia, Pa
> > ________________________________
> > From: Rhodes22-list <rhodes22-list-bounces at rhodes22.org> on behalf of
> Bob
> > Garrant <bgarrant at gmail.com>
> > Sent: Monday, July 25, 2022 2:23 PM
> > To: The Rhodes 22 Email List <rhodes22-list at rhodes22.org>
> > Subject: [Rhodes22-list] In-hull transducer?
> >
> > Hi folks,
> > I am installing an in-hull transducer.
> > I'm trying to figure out where to locate it. Thinking about placing it
> > below
> > the cabin floor just offset from the centerboard sleeve.
> > Wondering if anyone in the group has installed an in-hill transducer and
> > how
> > it was done.
> > Thanks very much
> > Bob Garrant
> > Sail la Vie
> > Kent Island, MD
> >
> >
> >
>