[Rhodes22-list] Centerboard question

[Steve Alm]

Chris,
Very interesting.  My CB thumps too--esp. when going downwind and the boat
is yawing a little.  I've thought about using that 1/4" plastic or nylon or
whatever to fix the slop in my rudder, but it's nice to know it has the CB
application as well.  I'll keep that in mind.  Did you use the self-adhesion
stuff?  
Slim

On 4/6/04 10:51 PM, "napoli68 at charter.net" <napoli68 at charter.net> wrote:

> I Just had the cap off my '83 for general inspection and to replace the
> pennent.  The board had a bit of slop and would thump if the boat rocked.  I
> took the pin and the bushing from the centerboard.  There was a fair amount of
> wear in both the pin and bushing my guess it was original. I had a friend
> machine anothe pin and bushing to close tollerences and reinstalled.  I also
> cut 2 4" disks out of a tough plastic and placed them on either side of the
> pin (had to grind down the plastic to get the right thickness.  There is still
> plenty of room for the board to rise up in a horizontal position if I ground
> the keel itself. 
> 
> I took the boat south to the Sacramento Delta for a few days and all was
> quiet.  Must say I've never sailed there, some of sloughs and "parcels" remind
> me of the southern Chesapeake but other were sureal.  I'm just not sued to
> broad reaching in 18 knots of wind on flat water looking DOWN at farm fields
> and cows 20 feet below me.  Good trip though, just wish I knw how to post some
> pics on the net to share.
> 
> Chris G.
> Medford OR
>> 
>> From: "Mark Kaynor" <mark at kaynor.org>
>> Date: 2004/04/06 Tue PM 02:52:12 GMT
>> To: "cjlowe" <cjlowe at bright.net>,
>>         "The Rhodes 22 mail list" <rhodes22-list at rhodes22.org>
>> Subject: RE: [Rhodes22-list] Centerboard question
>> 
>> Jerry,
>> 
>> That's exactly what I was looking for. Raven's an '88, so I expect the
>> centerboard design is the same as Country Rhodes'. Thanks.
>> 
>> Mark
>> 
>> 
>> -----Original Message-----
>> From: rhodes22-list-bounces at rhodes22.org
>> [mailto:rhodes22-list-bounces at rhodes22.org]On Behalf Of cjlowe
>> Sent: Monday, April 05, 2004 9:44 PM
>> To: The Rhodes 22 mail list
>> Subject: Re: [Rhodes22-list] Centerboard question
>> 
>> 
>> Mark,
>> the CB fits down in a V'ed out slot on each side of the CB trunk.the  V on
>> each side of the trunk is about 2" at the top, tapering down to the size of
>> the pin at the bottom.It's about 5" long,(just guessing,I looked at it 4
>> hours ago when I first saw your e-mail,didn't actually measure anything)
>> It's only held in there by the pin protruding through the CB and resting in
>> the bottom of the V on each side of the trunk(by gravity).I think if you
>> released the CB pendent (with the boat on the trailer),grabbed the aft end
>> of the CB, lifting  up(to put most of the weight  on the CB pin) and pushing
>> fore and aft ( horizontally) the amount of slop should indicate the
>> condition of the unit.I have  my CB out right  now for repair & painting, so
>> I have easy access.If you need more info. let me know. My boat is a 1986
>> R-22.
>> 
>> Jerry Lowe
>> S/V  Country Rhodes
>> 
>> 
>> __________________________________________________
>> Use Rhodes22-list at rhodes22.org, Help? www.rhodes22.org/list
>> 
>> __________________________________________________
>> Use Rhodes22-list at rhodes22.org, Help? www.rhodes22.org/list
>> 
> 
> __________________________________________________
> Use Rhodes22-list at rhodes22.org, Help? www.rhodes22.org/list