[Rhodes22-list] Remote Motor Control

[Ronald Lipton]

The remote control is mounted on the forward wall of the rear lazarette.
There is a woden backing board and the cables are then fed back through
the laz to the engine through one of those rubber seals.  The setup is
reasonably convenient - although on occasion I have bumped the throttle
lever when moving around the cockpit.  I can take a picture next
weekend if you would like.

Ron
----- Original Message ----- 
From: "Korsten, Mark A" <Mark.Korsten at med.va.gov>
To: "The Rhodes 22 mail list" <rhodes22-list at rhodes22.org>
Sent: Monday, May 10, 2004 8:55 AM
Subject: RE: [Rhodes22-list] Remote Motor Control


Where to you have the remote control mounted so it doesn't get in the way? I
just purchased a new Mercury 9.9 (4 cycle) with remote control for my 1988
Rhodes 22. Thanks

-----Original Message-----
From: rhodes22-list-bounces at rhodes22.org
[mailto:rhodes22-list-bounces at rhodes22.org]On Behalf Of Ronald Lipton
Sent: Saturday, May 08, 2004 6:48 PM
To: The Rhodes 22 mail list
Subject: [Rhodes22-list] Remote Motor Control


I have a Quicksilver remote control connected to a Mercury
9.9 electric start outboard on my '89.  I seem to have lost
the lost the setup instructions.  Does anyone have a similar
setup and maybe  copy of the the instructions?  I can probably
figure it out myself but I would feel a bit more warm and
fuzzy if I had a copy of the instructions.

Ron
s/v Empress of Blandings

__________________________________________________
Use Rhodes22-list at rhodes22.org, Help? www.rhodes22.org/list
__________________________________________________
Use Rhodes22-list at rhodes22.org, Help? www.rhodes22.org/list