[Rhodes22-list] Stainless Steel Cutting Question

[Robert Skinner]

Power nibbler.
/Robert

Brad Haslett wrote:
> Dear Rhodies,
>
> I need to cut an inspection panel about 1" x 4" in a stainless steel duct
> that is located in tight confines.  My brother suggests a plasma torch but I
> have some concerns about the current involved since some very expensive
> electronics are located nearby.  Is there a Dremel cut-off wheel up to the
> task or another tool/technique adequate for thin wall stainless? (guessing
> 1/16" thick).
>
> Brad
> __________________________________________________
> To subscribe/unsubscribe or for help with using the mailing list go to http://www.rhodes22.org/list
> __________________________________________________
>
>