[Rhodes22-list] Stainless Steel Cutting Question

[Brad Haslett]

Robert,

Great for aluminum, will it work on SS?  I have zero experience working with
stainless sheet steel.

Brad

On Sat, Aug 16, 2008 at 7:28 PM, Robert Skinner <Robert at squirrelhaven.com>wrote:

> Power nibbler.
> /Robert
>
> Brad Haslett wrote:
> > Dear Rhodies,
> >
> > I need to cut an inspection panel about 1" x 4" in a stainless steel duct
> > that is located in tight confines.  My brother suggests a plasma torch
> but I
> > have some concerns about the current involved since some very expensive
> > electronics are located nearby.  Is there a Dremel cut-off wheel up to
> the
> > task or another tool/technique adequate for thin wall stainless?
> (guessing
> > 1/16" thick).
> >
> > Brad
> > __________________________________________________
> > To subscribe/unsubscribe or for help with using the mailing list go to
> http://www.rhodes22.org/list
> > __________________________________________________
> >
> >
> __________________________________________________
> To subscribe/unsubscribe or for help with using the mailing list go to
> http://www.rhodes22.org/list
> __________________________________________________
>