[Rhodes22-list] pop-top enclosure snap locations

[Arthur H. Czerwonky]

Chet

-----Original Message-----
>From: chetc <cclocksin at buckeye-express.com>
>Sent: Jun 9, 2008 2:17 PM
>To: rhodes22-list at rhodes22.org
>Subject: [Rhodes22-list]  pop-top enclosure snap locations
>
>
>I am trying to fit up a used Pop-Top enclosure from Stan the Man, and our
>boat doesn't have the "studs" for the enclosure. Stan says it is easiest to
>put the studs on the cabin top first, and then put snaps in the enclosure in
>the matching location. Reason for this method is to keep the studs on the
>cabin top all looking neat and straight, since you see them all of the time.
>Sounds good, and I think I'll try that, but I wanted to ask if anybody out
>there who has a PTE could post a couple of pictures of the stud/snaps on the
>boat so I can at least get a rough idea of where to locate them (ie: 1/2"
>down from the top of the cabin?)...and, since the enclosure has snaps
>already...I might try to place studs on the boat to match at least some of
>the snaps (corners?) that are already installed on the enclosure. 
>
>I was finally able to take the enclosure down to the boat to see if it looks
>like it will work, and it sure will, but it could be trick to get the studs
>on correctly so that it fits snug. Anybody done this?
>-- 
>View this message in context: http://www.nabble.com/pop-top-enclosure-snap-locations-tp17738687p17738687.html
>Sent from the Rhodes 22 mailing list archive at Nabble.com.
>
>__________________________________________________
>Use Rhodes22-list at rhodes22.org, Help? www.rhodes22.org/list