[Rhodes22-list] installing new floor

Tue Jan 13 20:57:26 EST 2015

Sure thing Graham.  I will post pics and keep everyone updated.  I welcome lots of advice but am a brave (if not foolish) do it yourselfer.
I once rebuild the stringers in a similar boat and bedded the pressure treated pine stringers in polyurethane construction adhesive. (Moisture cure stuff from home depot)
I sailed the boat hard for years, had it fill up with water once for a month.  When i sold it i got down in there to inspect and the job looked brand new and the adhesive was still perfectly holding the stringers to the hull.
I would say epoxy would be a much better choice and a few layers of fiberglass cloth and resin even better.
Bob

> On Jan 13, 2015, at 8:37 PM, The Rhodes 22 Email List <rhodes22-list at rhodes22.org> wrote:
> 
> Last summer I removed all of the stringers and end pieces for the floor
> structure as I needed better access to the area over the keel. The frames
> had been replaced by a previous owner who used pressure treated fence
> boards. After more than 15 years the boards were still perfectly sound. At
> one point I decided to add glass to bond the boards to the hull better and
> was not sure if the epoxy would bond with the boards given the treatment.
> The epoxy held firm - as I discovered when I removed them this summer. 
> 
> The problem with using fence boards is that they are only 1/2 inch thick and
> that gives a very small edge area to drive the screws for the floorboards,
> When I redo it I will either use pressure treated deck boards that are 5/4
> inch thick or white oak if I can get some at a reasonable cost. I think
> using 2" material is a bit overkill but I have no idea what was/is being
> used by General Boats. But based on my experience, it appears that the
> pressure treated pine works fine. The stuff they make today is much less
> toxic than what they were using before, it is all under the floor boards and
> in my case will be coated in epoxy so I don't think the toxic properties are
> something to worry about. 
> I will be interested to learn about how others are approaching the
> installation of the framing. So please post what you do and how it worked
> out.
> 
> Graham 
> 
> 
> 
> -----Original Message-----
> From: rhodes22-list-bounces at rhodes22.org
> [mailto:rhodes22-list-bounces at rhodes22.org] On Behalf Of The Rhodes 22 Email
> List
> Sent: January-13-15 8:13 PM
> To: The Rhodes 22 Email List
> Subject: Re: [Rhodes22-list] Centerboard cap
> 
> I was thinking of using pressure treated pine
> 
>>> On Jan 13, 2015, at 6:53 PM, The Rhodes 22 Email List
>> <rhodes22-list at rhodes22.org> wrote:
>> 
>> It would be great to see your plan and pics.
>> 
>> It sounds like you're a step ahead of us. We're still sanding out the 
>> area where the stringers were and fitting the new ones. We're using 
>> 2x6 white oak
>> 
>> Larry Allen
>> Sarasota
>> larrywallen at veizon.net
>> 941-914-4065
>> 
>> 
>> -----Original Message-----
>> From: rhodes22-list-bounces at rhodes22.org
>> [mailto:rhodes22-list-bounces at rhodes22.org] On Behalf Of The Rhodes 22 
>> Email List
>> Sent: Tuesday, January 13, 2015 2:45 PM
>> To: The Rhodes 22 Email List
>> Subject: Re: [Rhodes22-list] Centerboard cap
>> 
>> Yes it is a 1983 rhodes and is in good shape except for the rotted 
>> floor.  I will email you my plan and pics if you want.
>> Also to Graham.  Thanks for the input.  I think i may as well tackle it
> now.
>> I also think i am going to remove the rub rail in the attempt to stop 
>> the rainwater that works in.
>> Turning into a refit! 
>> 
>>>> On Jan 13, 2015, at 12:24 PM, The Rhodes 22 Email List
>>> <rhodes22-list at rhodes22.org> wrote:
>>> 
>>> We're doing exactly the same project. I'd like to talk with you or 
>>> get some information about how you're going to install the stringers 
>>> and what you're using. We also removed the centerboard cap to inspect 
>>> the board and the hull well. It's a 1986 R22
>>> 
>>> Larry Allen
>>> Sarasota
>>> "Makai"
>>> larrywallen at verizon.net
>>> 941-914-4065
>>> 
>>> 
>>> -----Original Message-----
>>> From: rhodes22-list-bounces at rhodes22.org
>>> [mailto:rhodes22-list-bounces at rhodes22.org] On Behalf Of The Rhodes 
>>> 22 Email List
>>> Sent: Tuesday, January 13, 2015 11:45 AM
>>> To: The Rhodes 22 Email List
>>> Subject: [Rhodes22-list] Centerboard cap
>>> 
>>> Ok, so i am getting ready to rebuild my floor.  Its all clean and 
>>> ready to put the stringers in and i am looking at the centerboard cap 
>>> and wondering if i should take it apart and inspect it all.  The line 
>>> looks good and it works. Some of the gelcoat is chipped off the cb.
>>> Three of the cb cap screws are mild steel and rusty.
>>> Advice?
>>> 
>>> Bob (palatka fl)
>>> "Saved by Grace"
>>> The name comes from the fact that with each child i agreed to it if i 
>>> could buy a boat!  Haha! So our fourth and last :-) was a beautiful 
>>> little girl named...Grace.
>>> __________________________________________________
>>> To subscribe/unsubscribe go to
>>> http://www.rhodes22.org/mailman/listinfo/rhodes22-list
>>> 
>>> For the list Charter and help with using the mailing list and 
>>> archives go to http://www.rhodes22.org/list 
>>> __________________________________________________
>>> 
>>> 
>>> __________________________________________________
>>> To subscribe/unsubscribe go to
>>> http://www.rhodes22.org/mailman/listinfo/rhodes22-list
>>> 
>>> For the list Charter and help with using the mailing list and 
>>> archives go to http://www.rhodes22.org/list 
>>> __________________________________________________
>> 
>> __________________________________________________
>> To subscribe/unsubscribe go to
>> http://www.rhodes22.org/mailman/listinfo/rhodes22-list
>> 
>> For the list Charter and help with using the mailing list and archives 
>> go to http://www.rhodes22.org/list 
>> __________________________________________________
>> 
>> 
>> __________________________________________________
>> To subscribe/unsubscribe go to 
>> http://www.rhodes22.org/mailman/listinfo/rhodes22-list
>> 
>> For the list Charter and help with using the mailing list and archives 
>> go to http://www.rhodes22.org/list 
>> __________________________________________________
> 
> __________________________________________________
> To subscribe/unsubscribe go to
> http://www.rhodes22.org/mailman/listinfo/rhodes22-list
> 
> For the list Charter and help with using the mailing list and archives go to
> http://www.rhodes22.org/list
> __________________________________________________
> 
> __________________________________________________
> To subscribe/unsubscribe go to http://www.rhodes22.org/mailman/listinfo/rhodes22-list
> 
> For the list Charter and help with using the mailing list and archives go to http://www.rhodes22.org/list
> __________________________________________________