[Rhodes22-list] CB pennant hose replacement.

[The Rhodes 22 Email List]

Thanks Rummy!
Believe it or night i woke up at 4 am thinking the same thing!

> On Jan 30, 2015, at 8:23 AM, The Rhodes 22 Email List <rhodes22-list at rhodes22.org> wrote:
> 
> For future reference, next time you replace the pennant tube, most people  
> use double clamps on each end if there is enough room for them.
> 
> Rummy
> 
> 
> In a message dated 1/30/2015 6:19:48 A.M. Eastern Standard Time,  
> rhodes22-list at rhodes22.org writes:
> 
> The hose  segment needed was 16" long.  Placed two stainless hose clamps on 
> hose  prior to threading line through. Fiberglass had a cut out to allow a 
> small  ratchet access to tighten the upper clamp to the through hull. ( 
> Thanks Stan!)  My three year old supervised.  Job rating was: easy and takes 15 
> min....  30 minutes with a three year old supervising due to the  
> question...Why?
> 
> Bob  (palatka)
> 
> 
> __________________________________________________
> To  subscribe/unsubscribe go to  
> http://www.rhodes22.org/mailman/listinfo/rhodes22-list
> 
> For the list  Charter and help with using the mailing list and archives go 
> to  http://www.rhodes22.org/list
> __________________________________________________
> 
> __________________________________________________
> To subscribe/unsubscribe go to http://www.rhodes22.org/mailman/listinfo/rhodes22-list
> 
> For the list Charter and help with using the mailing list and archives go to http://www.rhodes22.org/list
> __________________________________________________