[Rhodes22-list] CB Pennant drain

Fri Aug 21 23:08:04 EDT 2020

Hi Mark, somehow I missed your reply from before.  I removed the wood
covering and it looks like mine has a single hose which is pretty straight
forward so I think I'll leave that in place and just thread the new line
through.  See the attached photo for the setup on my boat.

What is the length of the CB pennant line that you used?  I'll be
attempting the CB pennant replacement a week from tomorrow by attaching the
new line to the old line and pulling the new line through.  I'll be untying
(or cutting off) the old line underwater (using SCUBA gear) and tying on
the new line with a bowline.  I think I'll need to first secure the
diamondboard with a line from the stern and perhaps with another line
around the beam as well so that when I remove the old pennant, the
diamondboard doesn't continue to pivot any further and drop all the way
down to vertical.  When I'm at my slip, the diamondboard bottom should only
be about 18" off the bottom when extended so I could use a bucket to prop
it up as well.  I'm still thinking through my options...

On Thu, Aug 13, 2020 at 9:06 AM Mark Whipple <mark at whipplefamily.com> wrote:

> Jesse,
>
> On my boat the drain was behind a teak or oak covering which was attached
> to the boat with screws and small angle brackets. I'll try to remember to
> take pictures when I reassemble things. It was pretty easy for me to
> remove. Sounds like your boat may be a little different.
>
> Mark
>
> On Thu, Aug 13, 2020 at 9:31 AM Jesse Shumaker <
> jesse.laten.shumaker at gmail.com> wrote:
>
> > Mark, thanks for sharing.
> >
> > On my 1991 R22, it appears that the CB pennant hoses are aft of the cabin
> > and forward of the cockpit so they are hidden from view.  If I had to
> > access that, I assume that I would need to cut out a panel of the
> > fiberglass at the aft of the cabin.  Has anyone on the list done that?  I
> > ask because I'm going to be replacing my centerboard pennant at the end
> of
> > the season.  I plan to use a messenger line to accomplish this and plan
> to
> > leave the existing hoses in place but in case that goes poorly, it would
> be
> > good to have a backup plan.
> >
> > Jesse Shumaker
> > S/V Zephyr
> >
> > On Thu, Aug 13, 2020 at 8:21 AM Mark Whipple <mark at whipplefamily.com>
> > wrote:
> >
> > > Just in case you wanted to know the rest of the story:
> > >
> > > Yesterday I finally got around to completing the replacement of drain
> on
> > > the bridge deck that the centerboard pennant runs through. I have a
> 2000
> > > Rhodes 22.
> > >
> > > It took a little bit of experimentation but I found a 1 1/4" ID hose
> fits
> > > the upper part of the drain and a 3/4" hose fits on the bottom. I got
> a 1
> > > 1/4" to 3/4" adapter to join the two. Add some hose clamps, remember to
> > > thread the CB pennant through it all before installing, and then it's
> > just
> > > getting the lengths right so it can all go together but still be long
> > > enough to be clamped. Attached is a couple pics of the finished product
> > > along with the monstrosity I removed. What you don't see in the
> "before"
> > > shot is the completely rusted hose clamps that I had to use a Dremel to
> > > remove. The slit in the old hose is also from the removal process.
> > >
> > > Mark
> > > --
> > > Boston, MA
> > >
> > > 2000 R22 *Luna Mia*
> > > 1987 Nimble 30 *For Sale*
> > > 1982 Com-Pac 16 *For Sale*
> > >
> > > On Mon, Jun 15, 2020 at 8:10 PM Mark Whipple <mark at whipplefamily.com>
> > > wrote:
> > >
> > > > Hi All,
> > > >
> > > > If this is in the archives somewhere let me know. I've done a little
> > > > searching on Nabble and didn't find what I needed. I need to replace
> > the
> > > > hose that connects the drain the CB/diamondboard pennant runs
> through.
> > > >
> > > > It looks like the OD of the lower section (closer to the CB) is 7/8"
> > OD.
> > > > The top section where the pennant exits is about 1" ID, so I'm
> guessing
> > > > it's about 1 1/4" OD. Total possible length looks to be about 10".
> The
> > > > difference in diameters partially explains the abomination that I
> > > removed.
> > > > Someone tried to mate two different hoses with clamps and lots of
> > > silicone.
> > > >
> > > > What has worked well for you in replacing this drain hose? I am
> > wondering
> > > > if I can get a hose that will fit the upper part of the drain, and
> then
> > > use
> > > > a modified section of that same hose to bring the bottom fitting
> closer
> > > to
> > > > 1 1/4". Then I'd put the larger hose over the smaller one, clamping
> the
> > > > smaller section low and then the larger, overlapping hose as well.
> > > >
> > > > Thanks
> > > > Mark Whipple
> > > > Boston, MA
> > > >
> > > > 2000 R22 Luna Mia
> > > > 1987 Nimble 30 (for sale)
> > > > 1982 ComPac 16 (for sale)
> > > >
> > > >
> > > >
> > > -------------- next part --------------
> > > A non-text attachment was scrubbed...
> > > Name: 20200812_182047.jpg
> > > Type: image/jpeg
> > > Size: 109027 bytes
> > > Desc: not available
> > > URL: <
> > >
> >
> http://rhodes22.org/pipermail/rhodes22-list/attachments/20200813/110893e8/attachment.jpg
> > > >
> > > -------------- next part --------------
> > > A non-text attachment was scrubbed...
> > > Name: 20200812_182100.jpg
> > > Type: image/jpeg
> > > Size: 267020 bytes
> > > Desc: not available
> > > URL: <
> > >
> >
> http://rhodes22.org/pipermail/rhodes22-list/attachments/20200813/110893e8/attachment-0001.jpg
> > > >
> > > -------------- next part --------------
> > > A non-text attachment was scrubbed...
> > > Name: 20200813_082227.jpg
> > > Type: image/jpeg
> > > Size: 285444 bytes
> > > Desc: not available
> > > URL: <
> > >
> >
> http://rhodes22.org/pipermail/rhodes22-list/attachments/20200813/110893e8/attachment-0002.jpg
> > > >
> > > -------------- next part --------------
> > > A non-text attachment was scrubbed...
> > > Name: 20200813_082201.jpg
> > > Type: image/jpeg
> > > Size: 288970 bytes
> > > Desc: not available
> > > URL: <
> > >
> >
> http://rhodes22.org/pipermail/rhodes22-list/attachments/20200813/110893e8/attachment-0003.jpg
> > > >
> > >
> >
>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: CBpennantDrainHose.jpg
Type: image/jpeg
Size: 97525 bytes
Desc: not available
URL: <http://rhodes22.org/pipermail/rhodes22-list/attachments/20200821/83c1bc73/attachment.jpg>