[Rhodes22-list] Mooring advice

[Matt Wilson]

Thanks guys,

What’s the best way to attach a line to the bottom of the mooring ball. A
metal shackle and bowline? Anchor hitch?

The fiberglass appears to be totally intact.  I never found the U ring but
one of the bolts was still in there broken cleanly some rust present the
backing plate on my 1990 boat appears to be wood and there was no metal
plate present either on the outside or inside. We had a sudden gust about
40mph maybe a bit more on a windy but sunny day. Thanks for the warning on
the glass. I’ll look again more closely tomorrow but I didn’t see anything
as I was installing the new one.



On Sat, Jun 8, 2024 at 7:56 PM Graham Stewart <gstewart.gm at gmail.com> wrote:

> I would go with a double line (3/8 or larger)  that goes through the chocks
> to the bow cleat. I would not use the bow ring.
> Graham Stewart
> gstewart.gm at gmail.com
>
>
> On Sat, Jun 8, 2024 at 5:05 PM Matt Wilson <mwhornblower at gmail.com> wrote:
>
> > Thank you Stewart,
> >
> > I know these are general boating questions so thanks for the help. What
> > size and type of line would you recommend?
> >
> > Matt Wilson
> > Hornblower II
> > White Bear Lake MN
> >
> > On Sat, Jun 8, 2024 at 3:41 PM Graham Stewart <gstewart.gm at gmail.com>
> > wrote:
> >
> > > Are you connecting the bow ring to the mooring with chain alone? If so,
> > you
> > > run the risk of wearing right through the metal hardware or chain. The
> > > connection to the boat should  always use lines. You can add a snuber
> for
> > > shock reduction.
> > >
> > > Graham Stewart
> > > gstewart.gm at gmail.com
> > >
> > >
> > > On Sat, Jun 8, 2024 at 1:04 PM Matt Wilson <mwhornblower at gmail.com>
> > wrote:
> > >
> > > > Sorry everyone,
> > > >
> > > > I spent a few hours putting in a new, heavier bow ring and then we
> had
> > > > folks out for a stunning sunset sail.
> > > >
> > > >
> > > >
> > > > Yes the ring that attaches the boat to the trailer. That ring was
> > > attached
> > > > to my mooring and broke from fatigue during a 40 mph sustained gust.
> I
> > > use
> > > > a chain on a mooring on a fairly  large MN lake.  It’s mostly
> sheltered
> > > but
> > > > when those SE breezes come up there is about 1.5 mi of open water so
> > > there
> > > > can be a fair amount of wave action on top of sustained 20mph winds
> at
> > > > times.
> > > >
> > > > Should I be concerned that the boat fiberglass could be damaged?  Any
> > > > thoughts on some kind of spring or a better set up?
> > > >
> > > > Thanks so much,
> > > > Matt Wilson
> > > > HornblowerII
> > > > White Bear Lake, MN
> > > >
> > > > On Fri, Jun 7, 2024 at 4:13 PM ROGER PIHLAJA <roger_pihlaja at msn.com>
> > > > wrote:
> > > >
> > > > > Hi Larry,
> > > > >
> > > > > Are you referring to the ring on the bow which is used to winch the
> > > boat
> > > > > onto the trailer?  Does the bow have a big hole where the ring used
> > to
> > > > be?
> > > > > What sort of conditions did it take to do that?  What are you going
> > to
> > > > have
> > > > > to do to repair ?
> > > > >
> > > > > Does your boat have bow line chocks?  If yes, then just route the
> > > mooring
> > > > > line from the bow cleat thru the line chock and down to the mooring
> > > buoy.
> > > > > You could rig a bridle thru each line chock.  But, the boat won’t
> > ride
> > > > too
> > > > > far off center with just one.  I wouldn’t bother with rigging the
> 2nd
> > > > > line.  I presume this will be temporary?
> > > > >
> > > > > Roger Pihlaja
> > > > > S/V Dynamic Equilibrium
> > > > > 1978. Sanford, MI
> > > > >
> > > > > Sent from my iPhone
> > > > >
> > > > > > On Jun 7, 2024, at 3:36 PM, Larry Gioia via Rhodes22-list <
> > > > > rhodes22-list at rhodes22.org> wrote:
> > > > > >
> > > > > >  I've seen setups where a yoke is created by a line tied at each
> > end
> > > > to
> > > > > the 2 foredeck cleats and leading around the bow, connected to a
> > > separate
> > > > > line that goes to the mooring.
> > > > > > And I am curious about that sheared bow ring.
> > > > > > Larry
> > > > > >    On Friday, June 7, 2024 at 03:29:27 PM EDT, Matt Wilson <
> > > > > mwhornblower at gmail.com> wrote:
> > > > > >
> > > > > > Hi everyone,
> > > > > >
> > > > > > I just had a bow ring shear off during a storm.  Any advice on
> > > mooring
> > > > > to a
> > > > > > buoy without one…just using the foredeck cleat.
> > > > > >
> > > > > > Much appreciated,
> > > > > > Matt Wilson
> > > > > > Hornblower II
> > > > > > White Bear Lake, MN
> > > > > >
> > > > >
> > > >
> > >
> >
>