[Rhodes22-list] Mast step repair

[Graham Stewart]

If the stainless steel metal base is bent it will likely be very difficult
to flatten. I replaced mine a few years back and, as I recall, it cost
about $55.

Graham Stewart
gstewart.gm at gmail.com


On Wed, Jun 19, 2024 at 1:53 PM Bob Allen <rca02536 at gmail.com> wrote:

> While launching, the mast leaned to the side and lifted the mast step off
> its pad in one corner.  The all screws tighten, but the whole step lifts up
> in  the aft starboard corner.  What is the best way to repair it?